随笔分类 - Cisco
摘要:1. The BGP table plays a key role in the process of learning using routing information with BGP. A router stores all learned BGP prefixs and PAs in it
阅读全文
摘要:1. BGP first forms a neighbor relationship with peers. BGP then learns information from its neighbors , placing that information in a table the BGP ta
阅读全文
摘要:1. The single biggest reason to consider using BGP between an enterprise and an ISP is to influence the choice of best path(best route). 2. Running BG
阅读全文
摘要:1. Border Gateway Protocol advertises , learns , and choosed the best paths inside the global Internet.When two ISPs connect , they typically use BGP
阅读全文
摘要:Topology 1. DNAT (Dynamic) int fa0/0 ip nat inside int fa0/1 ip nat outside ip nat pool ISP-POOL 198.51.100.3 192.51.100.14 netmask 255.255.255.240 ip
阅读全文
摘要:通用路由封装(英语:Generic Routing Encapsulation,缩写为GRE),一种隧道协议,可以在虚拟点对点链路中封装多种网络层协议。由思科系统开发以下是GRE协议的简单练习网络拓扑如下:路由器的基本配置如下1.配置基本的IP地址信息2.配置隧道接口(R1如下)interface ...
阅读全文
摘要:Supporting Connected Routes to Subnet ZeroIOS allows the network engineer to tell a router to either allow addresses in the zero subnet or not. The mo...
阅读全文
摘要:Operating Cisco Routerconsider the hardware on the ends of the serial link, in particular where the channel service unit/data service unit (CSU/DSU) h...
阅读全文
摘要:Basic Vlan CLI ConfigureSwitch>enSwitch#conf tEnter configuration commands, one per line. End with CNTL/Z.Switch(config)#vlan 10Switch(config-vlan)#na...
阅读全文
摘要:1. Vlan Benefit·To reduce CPU overhead on each device by reducing the number of devices that receive each broadcast frame• To reduce security risks by...
阅读全文
摘要:Cisco IOS Basic CLI Configuration : Switch Port Command1. BasicSwitch>enSwitch#conf tEnter configuration commands, one per line. End with CNTL/Z.Switc...
阅读全文
摘要:1. TelnetSwitch Config:Switch>enSwitch#conf tEnter configuration commands, one per line. End with CNTL/Z.Switch(config)#enable secret zhangSwitch(conf...
阅读全文

浙公网安备 33010602011771号