Screen shot of new version
screen shot of new version
2006/5/24 8:05:43
[root@localhost app]# ./simos
==================================sibyte simulator hardware configration============================
SIBYTE SIM MACHINE CONFIGRATION:
machine num: 1
max cpus per machine: 2
max ether controller per machine: 3
cell mode : off
prom path: /usr/src/simos/kernels/cfe
CPU CONFIGRATION:
cpu type: mipsy
cpu number per machine: 2
MEMORY SYSTEM CONFIGRATION:
memory bank: 1
memory size: 64
LOG CONFIGRATION:
loop_on_error : on
cpu_error_loop: on
error_keep_logs: on
log file: ./cpu.log
DEBUG CONFIGRATION:
debug flags:
listen port: 5000
debug mode: off
callback interval: 5000
GENBUS CONFIGRATION:
kernel rom path: /usr/src/simos/kernels/vmlinux.smp
DUART CONFIGRATION:
callback_interval: 5000
ETHER CONFIG:
callback interval: 500
SCD CONFIGRATION:
callback interval: 5000
=======================================================================================================
!! Could not open NVRAM device eeprom0
CFE version 1.2.5 for SWARM (64bit,MP,BE,MIPS)
Build Date: Mon Apr 17 07:46:21 CST 2006 (root@gkong)
Copyright (C) 2000,2001,2002,2003,2004,2005 Broadcom Corporation.
Initializing Arena.
Initializing Devices.
SWARM board revision 1
sbeth: found phy 0, vendor 3FFFBF part 3F
Config switch: 0
CPU: BCM1250 rev 0x0
L2 Cache Status: OK
Wafer ID: Not set
SysCfg: 0000000000480080 [PLL_DIV: 1, IOB0_DIV: CPUCLK/4, IOB1_DIV: CPUCLK/3]
CPU type 0x1040100: 5KHz
Total memory: 0x4000000 bytes (64MB)
Total memory used by CFE: 0x81F00000 - 0x820039E0 (1063392)
Initialized Data: 0x81F00000 - 0x81F015F0 (5616)
BSS Area: 0x81F015F0 - 0x81F019E0 (1008)
Local Heap: 0x81F019E0 - 0x820019E0 (1048576)
Stack Area: 0x820019E0 - 0x820039E0 (8192)
Text (code) segment: 0x9FC00000 - 0x9FC37B95 (228245)
Boot area (physical): 0x02004000 - 0x02044000
Relocation Factor: I:00000000 - D:00000000
CFE> cpu1 start
Starting CPU 1 at 9fc1f774
Result 0
*** command status = 0
CFE> cpu1 stop
Stopping CPU 1
Result 0
*** command status = 0
CFE> ifconfig eth0 -addr=192.168.0.1
sbeth: found phy 0, vendor 3FFFBF part 3F
eth0: Link speed: 1000BaseT FDX
Device eth0: hwaddr 02-10-18-10-06-40, ipaddr 192.168.0.1, mask not set
gateway not set, nameserver not set
*** command status = 0
CFE> ping 192.168.0.2
192.168.0.2 (192.168.0.2) is not responding (seq=0)
192.168.0.2 (192.168.0.2): 1 packets sent, 0 received
*** command status = 1
CFE> ping 192.168.0.2
192.168.0.2 (192.168.0.2) is alive
192.168.0.2 (192.168.0.2): 1 packets sent, 1 received
*** command status = 0
CFE> ping 192.168.0.2
192.168.0.2 (192.168.0.2) is alive
192.168.0.2 (192.168.0.2): 1 packets sent, 1 received
*** command status = 0
CFE> boot -elf flash1:a
Loader:elf Filesys:raw Dev:flash1 File:a Options:(null)
Loading: 0xffffffff80100000/952076 0xffffffff801ea000/447292 0xffffffff8025733c/72948 Entry at 0x80204000
Closing network.
Starting program at 0x80204000
Broadcom SiByte BCM1250 A0-A6 @ 50 MHz (SB1 rev 0)
Board type: SiByte BCM91250A (SWARM)
WriteC0Reg zero bits set during write to 13 @0xffffffff8020aa9c RA 0xffffffff8020abf4, clearing
Linux version 2.6.14.3 (root@gkong) (gcc version 3.3.3 (DENX ELDK 3.1.1 3.3.3-9)) #75 SMP Wed May 24 10:03:52 CST 2006
CPU revision is: 01040100
This kernel optimized for simulation runs with CFE
Determined physical RAM map:
memory: 01effe00 @ 00000000 (usable)
memory: 01ffbe00 @ 02004000 (usable)
Built 1 zonelists
Kernel command line: root=/dev/ram0
Primary instruction cache 32kB, 4-way, linesize 32 bytes.
Primary data cache 48kB, 3-way, linesize 32 bytes.
Synthesized TLB refill handler (27 instructions).
Synthesized TLB load handler fastpath (41 instructions).
Synthesized TLB store handler fastpath (36 instructions).
Synthesized TLB modify handler fastpath (35 instructions).
PID hash table entries: 256 (order: 8, 4096 bytes)
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 61236k/64488k available (876k kernel code, 3112k reserved, 160k data, 336k init, 0k highmem)
Mount-cache hash table entries: 512
Checking for 'wait' instruction... unavailable.
Detected 1 available secondary CPU(s)
softlockup thread 0 started up.
WriteC0Reg zero bits set during write to 13 @0xffffffff8020aa9c RA 0xffffffff80109f0c, clearing
CPU revision is: 03040100
Primary instruction cache 32kB, 4-way, linesize 32 bytes.
Primary data cache 48kB, 3-way, linesize 32 bytes.
Synthesized TLB refill handler (27 instructions).
Brought up 2 CPUs
softlockup thread 1 started up.
Linux NoNET1.0 for Linux 2.6
PCI: Skipping PCI probe. Bus is not initialized.
io scheduler noop registered
Freeing unused kernel memory: 336k freed
gkong:main
Loading, please wait...
gkong:main
mkdir /proc
mount -t proc proc /proc
cat /proc/cmdline
root=/dev/ram0
==================================sibyte simulator hardware configration============================
SIBYTE SIM MACHINE CONFIGRATION:
machine num: 1
max cpus per machine: 2
max ether controller per machine: 3
cell mode : off
prom path: /usr/src/simos/kernels/cfe
CPU CONFIGRATION:
cpu type: mipsy
cpu number per machine: 2
MEMORY SYSTEM CONFIGRATION:
memory bank: 1
memory size: 64
LOG CONFIGRATION:
loop_on_error : on
cpu_error_loop: on
error_keep_logs: on
log file: ./cpu.log
DEBUG CONFIGRATION:
debug flags:
listen port: 5000
debug mode: off
callback interval: 5000
GENBUS CONFIGRATION:
kernel rom path: /usr/src/simos/kernels/vmlinux.smp
DUART CONFIGRATION:
callback_interval: 5000
ETHER CONFIG:
callback interval: 500
SCD CONFIGRATION:
callback interval: 5000
=======================================================================================================
!! Could not open NVRAM device eeprom0
CFE version 1.2.5 for SWARM (64bit,MP,BE,MIPS)
Build Date: Mon Apr 17 07:46:21 CST 2006 (root@gkong)
Copyright (C) 2000,2001,2002,2003,2004,2005 Broadcom Corporation.
Initializing Arena.
Initializing Devices.
SWARM board revision 1
sbeth: found phy 0, vendor 3FFFBF part 3F
Config switch: 0
CPU: BCM1250 rev 0x0
L2 Cache Status: OK
Wafer ID: Not set
SysCfg: 0000000000480080 [PLL_DIV: 1, IOB0_DIV: CPUCLK/4, IOB1_DIV: CPUCLK/3]
CPU type 0x1040100: 5KHz
Total memory: 0x4000000 bytes (64MB)
Total memory used by CFE: 0x81F00000 - 0x820039E0 (1063392)
Initialized Data: 0x81F00000 - 0x81F015F0 (5616)
BSS Area: 0x81F015F0 - 0x81F019E0 (1008)
Local Heap: 0x81F019E0 - 0x820019E0 (1048576)
Stack Area: 0x820019E0 - 0x820039E0 (8192)
Text (code) segment: 0x9FC00000 - 0x9FC37B95 (228245)
Boot area (physical): 0x02004000 - 0x02044000
Relocation Factor: I:00000000 - D:00000000
CFE> cpu1 start
Starting CPU 1 at 9fc1f774
Result 0
*** command status = 0
CFE> cpu1 stop
Stopping CPU 1
Result 0
*** command status = 0
CFE> ifconfig eth0 -addr=192.168.0.1
sbeth: found phy 0, vendor 3FFFBF part 3F
eth0: Link speed: 1000BaseT FDX
Device eth0: hwaddr 02-10-18-10-06-40, ipaddr 192.168.0.1, mask not set
gateway not set, nameserver not set
*** command status = 0
CFE> ping 192.168.0.2
192.168.0.2 (192.168.0.2) is not responding (seq=0)
192.168.0.2 (192.168.0.2): 1 packets sent, 0 received
*** command status = 1
CFE> ping 192.168.0.2
192.168.0.2 (192.168.0.2) is alive
192.168.0.2 (192.168.0.2): 1 packets sent, 1 received
*** command status = 0
CFE> ping 192.168.0.2
192.168.0.2 (192.168.0.2) is alive
192.168.0.2 (192.168.0.2): 1 packets sent, 1 received
*** command status = 0
CFE> boot -elf flash1:a
Loader:elf Filesys:raw Dev:flash1 File:a Options:(null)
Loading: 0xffffffff80100000/952076 0xffffffff801ea000/447292 0xffffffff8025733c/72948 Entry at 0x80204000
Closing network.
Starting program at 0x80204000
Broadcom SiByte BCM1250 A0-A6 @ 50 MHz (SB1 rev 0)
Board type: SiByte BCM91250A (SWARM)
WriteC0Reg zero bits set during write to 13 @0xffffffff8020aa9c RA 0xffffffff8020abf4, clearing
Linux version 2.6.14.3 (root@gkong) (gcc version 3.3.3 (DENX ELDK 3.1.1 3.3.3-9)) #75 SMP Wed May 24 10:03:52 CST 2006
CPU revision is: 01040100
This kernel optimized for simulation runs with CFE
Determined physical RAM map:
memory: 01effe00 @ 00000000 (usable)
memory: 01ffbe00 @ 02004000 (usable)
Built 1 zonelists
Kernel command line: root=/dev/ram0
Primary instruction cache 32kB, 4-way, linesize 32 bytes.
Primary data cache 48kB, 3-way, linesize 32 bytes.
Synthesized TLB refill handler (27 instructions).
Synthesized TLB load handler fastpath (41 instructions).
Synthesized TLB store handler fastpath (36 instructions).
Synthesized TLB modify handler fastpath (35 instructions).
PID hash table entries: 256 (order: 8, 4096 bytes)
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 61236k/64488k available (876k kernel code, 3112k reserved, 160k data, 336k init, 0k highmem)
Mount-cache hash table entries: 512
Checking for 'wait' instruction... unavailable.
Detected 1 available secondary CPU(s)
softlockup thread 0 started up.
WriteC0Reg zero bits set during write to 13 @0xffffffff8020aa9c RA 0xffffffff80109f0c, clearing
CPU revision is: 03040100
Primary instruction cache 32kB, 4-way, linesize 32 bytes.
Primary data cache 48kB, 3-way, linesize 32 bytes.
Synthesized TLB refill handler (27 instructions).
Brought up 2 CPUs
softlockup thread 1 started up.
Linux NoNET1.0 for Linux 2.6
PCI: Skipping PCI probe. Bus is not initialized.
io scheduler noop registered
Freeing unused kernel memory: 336k freed
gkong:main
Loading, please wait...
gkong:main
mkdir /proc
mount -t proc proc /proc
cat /proc/cmdline
root=/dev/ram0
浙公网安备 33010602011771号