hp 1810-24g switch reset
Specific
steps to execute the factory default reset on the switch are:
1.
Using a small, thin tool with blunt ends (such as a paper clip), simultaneously
press both the Reset and Clear buttons on the front of the switch.
2.
Continue to press the Clear button while releasing the Reset button.
3.
When all three Mode LEDs (Act, FDx, and Spd) begin to blink, release the Clear
button.
The
switch will then complete its self test and begin operating with its
configuration restored to the factory default settings.
Note:
After completing this procedure, there will be no password, the IP address will
be returned to the default 192.168.2.10, and all configuration settings will be
returned to factory defaults.
具体的步骤来执行恢复出厂设置:
1.使用一个又小又瘦的工具(如回形针),同时按下两个Reset和Clear的按键开关
2.继续按Clear按钮而释放Reset按钮
3.当所有三个模式LEDs(Act,
FDx, andSpd)开始闪烁,释放Clear按钮
交换机将完成自我测试,并开始操作其配置和恢复工厂默认设置
注意:在完成这个过程,就没有密码,IP地址将回到默认的192.168.2.10,所有配置设置将回到工厂默认值
