实验中心实验大纲

Lab 1: General Lab Setup / Basics
Basic router/switch configurations
Commands for router/switch Backups
Password recovery procedures
------------------------------------------------------------------------------------------------------
Lab 2: Frame Relay
Configuring Frame Relay Switch
Point-to-Multipoint Physical Interfaces
Point-to-Multipoint Sub-Interfaces
Point-to-Point Sub-interfaces
DLCI mapping
Traffic shaping
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 3: Integrated Services Digital Network (ISDN) for IP
Basic ISDN Configuration
Backup Interfaces
Dialer Profiles / Rotary groups
ISDN Traffic shaping
PPP Authentication (PAP,CHAP)
PPP Multi-link
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 4: Routing Information Protocol (RIP v1 & v2)
RIP Version 1 & 2
RIP authentication
Redistribution
Passive Interfaces Under RIP
Load balancing
RIP in discontiguous networks
RIP in WAN (Frame Relay and ISDN)
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 5: Interior Gateway Routing Protocol & Enhanced (IGRP /EIGRP)
IGRP and EIGRP configuration
Redistribution
Auto Summarization
EIGRP Passive Interface Configuration
Load balancing
IGRP and EIGRP in discontiguous networks
EIGRP in WAN (Frame Relay and ISDN)
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 6: Open Shortest Path First (OSPF)
OSPF in Single area
Multiple OSPF Areas
Redistribution
Virtual Links
Stub Areas, Totally Stub and Not so stubby areas
Link State Advertisement (LSA) Timers
OSPF in WAN/LAN (Ethernet, Frame Relay and ISDN)
OSPF in discontiguous areas
OSPF cost parameters (forced path selections)
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 7: Border Gateway Protocol (BGP)
EBGP IBGP
BGP attributes
BGP and IGPs
Synchronization
Policy Routing, Route-Maps and BGP Path selection
BGP Confederations
Route Reflectors
BGP Communities
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 8: Security
Access lists
NAT
VPN
PIX
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 9: General
Default Network / Gateway of Last Resort
Static & Default Routes
Passive Interface, Sub interfaceand loopback interface
Distribute Lists
Helper address
Hot standby routing protocol (HSRP)
Queuing (all types)
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 10: Catalyst Switch Configuration
VLAN configuration
ISL (Trunking)
Virtual Trunking Protocol (VTP)
Spanning Tree
Port Fast
SPAN (Switched Port Analyzer)
Address Resolution Protocol (ARP)
Cisco® Discovery Protocol (CDP)
Layer III switching (Configuring RSM)
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 11: Asynchronous Transfer Mode (ATM) Configuration
Configuration of ATM on routers
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 12: Voice
Configuring voice ports
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 13: Token Ring and IBM Technologies
Configuring Token ring switches
Data Link Switching Plus (DLSW+)
Transparent Bridging
Source Route Translational Bridging (SRT)
LLC2 Timers
SAP Filtering
Troubleshooting (debug and show commands)
 
------------------------------------------------------------------------------------------------------
Lab 14: Multicasting
Configuring Routers for Multicasting
Configuring Switches for multicasting
Configuring IGMP and CGMP
Rendezvous Point (RP)
Protocol Independent Multicast (PIM)
Troubleshooting (debug and show commands)
------------------------------------------------------------------------------------------------------
Lab 15: Simple Network Management Protocol (SNMP) and Cisco® View 2000
Cisco® view 2000
Defining SNMP Contact and Location Values
Maximum SNMP Packet Size
Enabling SNMP Traps
Defining SNMP Users
Defining Syslog Timestamps
Defining the Syslog Server
Defining the Size of the Syslog File
Defining Level of Debug Reporting to be Recorded in the Syslog
SNMP Public Community String
SNMP Private Community String
Troubleshooting (debug and show commands)