Recipe 1.8. Processing a String One Character at a Time

If you're processing an ASCII document, then each byte corresponds to one character. Use String#each_byte to yield each byte of a string as a number, which you can turn into a one-character string:

 'foobar'.each_byte { |x| puts "#{x} = #{x.chr}"}
2 #102 = f
3 #111 = o
4 #111 = o
5 #98 = b
6 #97 = a
7 #114 = r

 

Use String#scan to yield each character of a string as a new one-character string:

 'foobar'.scan(/./) { |c| puts c}
2 #f
3 #o
4 #o
5 #b
6 #a
7 #r

 

Since a string is a sequence of bytes, you might think that the String#each method would iterate over the sequence, the way Array#each does. But String#each is actually used to split a string on a given record separator (by default, the newline):

 "foo\nbar".each { |x| puts x }
2 #foo
3 #bar

 

String#each_byte is faster than String#scan, so if you're processing an ASCII file, you might want to use String#each_byte and convert to a string every number passed into the code block (as seen in the Solution).

If you have the $KCODE variable set correctly, then the scan technique will work on UTF-8 strings as well. This is the simplest way to sneak a notion of "character" into Ruby's byte-based strings.

 1 french = "\xc3\xa7a va"
 2 
 3 french.scan(/./) { |c| puts c }
 4 #
 5 #
 6 # a
 7 #
 8 # v
 9 # a
10 
11 
12 french.scan(/./u) { |c| puts c }
13 # ç
14 # a
15 #
16 # v
17 # a
18 
19 
20 $KCODE = 'u'
21 french.scan(/./) { |c| puts c }
22 # ç
23 # a
24 #
25 # v
26 # a