USB PE

To put WinPE on a USB Stick, you must first make it bootable.

Warning: This will destroy all the data on the USB Stick!

 

1. With your USB flash drive connected, click Start è All Programs è Accessories, then right-click Command Prompt and choose Run as administrator. (If you are using XP no need to choose Run as Administrator)

2. At the command prompt, type diskpart and press [Enter].

3. Type list disk followed by [Enter] and make a note of the number of your USB drive.

4. Type select disk <no> followed by [Enter] where <no> is the number of your drive noted in the last step.

5. Type clean followed by [Enter].

6. Type create partition primary followed by [Enter].

7. Type select partition 1 followed by [Enter].

8. Type active followed by [Enter].

9. Type format fs=NTFS followed by [Enter].

10. Type assign followed by [Enter].

11. Type exit followed by [Enter].