DELL PowerConnect 5548[初步]配置

Device

  • DELL PowerConnect 5548

Cable Connector

  • RS-232 cable with a male 8-pin RJ-45 connector

Software

Set the terminal emulation software as follows:

  • a Select the appropriate serial port to connect to the switch.
  • b Set the data rate to 9600 baud.
  • c Set the data format to 8 data bits, 1 stop bit, and no parity.
  • d Set Flow Control to none.
  • e Select VT100 for Emulation mode within your communication 
  • software.
  • f Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that 
  • the setting is for Terminal keys (not Windows keys).

Booting the Switch

  • After the local terminal is connected, turn on power.

Configuration Using the Setup Wizard

  • see [Configuration Using the Setup Wizard] @ Page 57 of <Dell PowerConnect 5500 Series System User Guide>
  • After the initial configuration is complete, you can manage the switch from the connected console port using the CLI or remotely through the management interface, using Telnet or the Web GUI.

About IP address (by myself)

  • an IP address can be set to the switch
  • there is no router included in the switch.

Reference

  • <Dell PowerConnect 5500 Series System User Guide>
  • <Dell PowerConnect 5500 Series Getting Started Guide>

posted on 2011-10-08 22:36  snigoal  阅读(1727)  评论(0)  编辑  收藏  举报